Good morning All,
I have a small problem regarding a Frequency simulation that I try to do it.
The component is a shell, all the pre-processing phase is good, but when I try to visualize the results there are some missing parts:
I can’t visualize all the results on the chart…
Where I did wrong?
I apply my file.
Analisi_modale_boccaglio.pmx (2.7 MB)
WBR
Marco F.
I tried a couple of time to redo the calculation, open/close all the file and now seems to work properly…
Strange behaviour, but now I have all the results 
Thank you very much for the support 
Have a nice day.
WBR
Marco F.
I’m glad it worked eventually. But if you encounter this issue again, check the job monitor for warnings and open the .dat file to see its contents. Then in such a case, please pack and share all the analysis files here for debugging.
